by Peter | Oct 27, 2015 |
A U-tube heat ex-changer. Heated water of 400° Kelvin transfers the heat to the water flowing through the copper tubes and visa versa. Heating the water in the copper tubes with Δ25 ° Kelvin A low inlet velocity of 0.15 m/s for the media flowing through the tubes and a velocity of 0.3 m/s for the media flowing in the outside tank. Heat conduction of 15 W/m² at the outer surfaces to simulate the temperature heat flux through the tank. Modelling 15% Meshing 30% Pre-processing 40% Post-processing...
by Peter | Oct 22, 2015 |
This project is a perfect example of what CAE Work is all about. It includes CAD optimization, CFD and FEM analyses. A 1 way fluid structure interaction simulations of multiple valve setups. The CFD results needed to be presented as velocity streamlines, Turbulent kinetic energy volume plot and a Temperature contour plot and for the mechanical results the total deformation and Von Mises stresses were required. The CFD pressure results are imported into the mechanical simulations and used as a input value. Tasks includes; A design optimization, CFD analyses and a FEM analyses of the ball valve. CAD optimization 20% CFD analysis 50% FEM analysis...
by Peter | Sep 30, 2015 |
Composite fibre spar with 0 – 90 and 45 – 45 lay-up. Tested on point compression. Made with Resin Transfer Moulding [RTM] technique. Design 10% Engineering 60% Production 20% Testing...
by Peter | Sep 30, 2015 |
The production of a carbon fibre composite wakeboard with a Nomex core. Prepreg carbon fibre was used to cover the Nomex core. Hardened by temperature under pressure in an autoclave. Design 30% Engineering 20% Production...
by Peter | Sep 18, 2015 |
Using different application to create a model and combining them to create a image. Creating a sense of understanding for 3D modelling and setting up the model for rendering. Modelling 60% Setup 10% Rendering...
