by Peter | Sep 18, 2015 |
Multiple simulation projects including, Heat convection Transient flow Naca 0012 simulation Saker sportscar diffuser research Radiation Pipe flow Pre-processing 20% Meshing 15% Simulating 25% Post-processing...
by Peter | Sep 18, 2015 |
A project that didn´t include much engineering, however due to the high quantity and value above 1 million Euro´s a very interesting project. Management 80% design 10% 3D CAD...
by Peter | Sep 18, 2015 |
Bearings holding the verticale poles in position. Made for the Nesserlande sluice – which goes from Belgium – The Netherlands Design 35% 3D CAD 25% Assembly 20% Management...
by Peter | Sep 18, 2015 |
This project contains the fabrication and testing of a buffer block. This project is executed incorporation with a rubber design, supplier and manufacturer. The hardest part of designing a bufferblok is to obtain the right stress – strain curve. Rubber acts different than isotropic material. It needs to be stiff, strong and at the same time flexible enough to obtain irregularities. Before these buffer blocks can be implemented they need to be tested under compression (angle) and shear. Design 30% Engineering 25% Testing 30% Management...
by Peter | Sep 17, 2015 |
Designed and produced for AXTech AS in Norway. This bearing has to endure the worst environmental conditions, while extremely high forces and moments acting on the bearing. To ensure survival, mulitple load cases have been simulated and computed to make sure this bearing does not fail. Design 20% 3D CAD 20% Engineering 30% Simiulation (FEM) 20% Management...
